Allied-telesis AT-S101 Manual do Utilizador descarregar pdf (Página 23)

AT-S101 Management Software User’s Guide

3. Change the IP configuration parameters by entering new information in

the following fields:

System MAC Address

This parameter displays the MAC address of the switch. You cannot

change this parameter.

System IP Address

Displays the current IP address of the switch. To change the IP

address, enter a new IP address.

System Subnet Mask

Displays the current subnet mask of the switch. To change the subnet

mask, enter a new subnet mask.

System Default Gateway

Displays the default gateway of the switch. To change the default

gateway, enter a new gateway.

DHCP Mode

For information about setting this parameter, refer to “Enabling and

Disabling the DHCP Client” on page 27.

4. Click Apply.

Note

Changing the IP address ends your management session. To

resume managing the device, enter the new IP address of the switch

in the web browser’s URL field, as shown in Figure 1 on page 14.

5. After you log on to the switch with the new IP address, select Save

Configuration to Flash to save the new IP address to memory.

Caution

If you do not select Save Configuration to Flash, the IP address

may revert to its default setting when you power cycle the switch.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 237 238

Sem comentários

Allied-telesis AT-S101 Manual do Utilizador Página 23