Allied-telesis AT-CV5001 Manual do Utilizador descarregar pdf (Página 69)

AT-CV5001 Media Converter Chassis Installation Guide

Removing or Replacing the AT-CV5001AC Power Supply

The AT-CV5001AC Power Supply is hot-swappable. You do not have to

power off the chassis to install a second power supply or to replace a

failed power supply in a chassis that has two power supplies.

There are two power supply slots. This procedure illustrates slot A. The

procedure is the same for slot B.

Note

The predecessor to the AT-CV5001 Chassis, the AT-CV5000

Chassis, had different power supply modules for the left and right

slots. This is not the case for the AT-CV5001AC Power Supply,

which can be installed in either power supply slot in the AT-CV5001

Chassis.

To remove or replace the AT-CV5001AC Power Supply, perform the

following procedure.

1. Disconnect the power cord from the power source.

2. Disconnect the power cord from the AT-CV5001AC Power Supply.

Figure 35. Removing the Power Cord from the AT-CV5001AC Power

Supply

T-CV5001

DISCONNECT ALL

WER SUPPLIES &

REFER

O MAN

AL BEFORE SE

RVICING

100-240VAC~

This unit

might h

ve more than one p

wer input

o reduce

of electric shoc

k, disconnect all po

wer inputs before ser

vicin

1671

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 85 86

Sem comentários

Allied-telesis AT-CV5001 Manual do Utilizador Página 69