Allied-telesis AT-FS704 Manual do Utilizador descarregar pdf (Página 27)

AT-FS704 Installation Guide

Hub-to-Switch Installation

A hub (10/100Base-TX) can be connected to the AT-FS704 using a two-pair

Category 5 UTP/STP RJ45 straight cable. Connect the hub uplink (MDI) port

to any of the switch (MDI-X) ports, 1X-4X. See Figure 7.

Figure 7

AT-FS704 Switch Connected to a 10/100Base-TX Hub

Hub-to-Switch Installation (without uplink port)

If a hub is not equipped with an uplink (MDI) port, then connection can be

made using either straight cable or crossover cable (see “Appendix A, Technical

Specifications” for cable requirements). Figure 8 demonstrates connection with

straight or crossover cable.

Figure 8

Switch Connected to Hub without Uplink (MDI) Port

1= X 2X 3X 4X

10BASE-T/100BASE-TX

4 PORT ETHERNET SWITCH

100M

LINK/ACT

FULL DUP

COLN

POWER

1234

To HUB To PC

1= X 2X 3X 4X

10BASE-T/100BASE-TX

4 PORT ETHERNET SWITCH

100M

LINK/ACT

FULL DUP

COLN

POWER

1234

To HUB To PC

HUB

Straight Cable

Crossover Cable

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

Sem comentários

Allied-telesis AT-FS704 Manual do Utilizador Página 27