Allied-telesis AT-FS716L Manual do Utilizador descarregar pdf (Página 28)

Chapter 2: Installation

Warning

Power cord is used as a disconnection device: To de-energize

equipment, disconnect the power cord.  5

6. Verify that the POWER LED is green. If the LED is OFF, refer to

“Troubleshooting” on page 34 for instructions.

Note

The switch perform a self-diagnostic test upon power up. This takes

about 20 seconds to complete.

7. Power ON the end-nodes connected to the switch.

8. Check that all the L/A LEDs are either green or orange. If any of the

LEDs is OFF, refer to “Troubleshooting” on page 34 for instructions.

The switch is now ready for use.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 61 62

Sem comentários

Allied-telesis AT-FS716L Manual do Utilizador Página 28