Allied-telesis AT-GS905 Manual do Utilizador descarregar pdf (Página 29)

AT-GS905 Gigabit Ethernet Switch Installation Guide

Cabling the Switch

To connect to the ports on the AT-GS905 switch, perform the following

procedure:

1. Connect the twisted pair data cables to the RJ-45 ports on the switch,

as illustrated in Figure 8.

Figure 8 Connecting the Twisted Pair Data Cables

2. Power on the end-nodes. For more information, refer to Powering

On the Switch on page 30.

When connecting a twisted pair cable to a port, observe the

following guidelines:

 An RJ-45 connector should fit snugly into the port on the switch.

The tab on the connector should lock the connector into place.

 The ports on the switch are auto-MDI/MDI-X. You can use either a

straight-through or crossover twisted pair cable to connect any

type of network device to a port on the switch.

 The network should not contain data loops, which can adversely

affect network performance. A data loop exists when two or more

network devices can communicate with each other over more

than one data path.

net

witch

POWER

34 5

100M

1000M

LNK/ACT

FDX

2341

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 48 49

Sem comentários

Allied-telesis AT-GS905 Manual do Utilizador Página 29