Allied-telesis AT-MCF2300 Manual do Utilizador descarregar pdf (Página 97)

Section II: Installation 97

Chapter 9

Removing the Rubber Feet

This procedure is optional. It is used to remove the rubber feet from the

bottom of the chassis. It should only be performed if you’ll be installing the

chassis in an equipment rack. By removing the rubber feet, it may be

possible to install the enclosure closer to the device below it, thus allowing

you to install more devices in the rack. To remove the rubber feet:

1. Place the unit upside down on a level, secure surface.

2. Using a flat-head screwdriver, remove the snap-on plastic feet from the

bottom of the chassis, as shown in Figure 42.

Figure 42. Removing the Chassis Feet

3. Return the chassis to the upright position.

4. Go to the next procedure for instructions on how to install a power

module.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 189 190

Sem comentários

Allied-telesis AT-MCF2300 Manual do Utilizador Página 97