Allied-telesis AT-MR840TF Manual do Utilizador descarregar pdf (Página 31)

Chapter 2

Installation

Before You Begin

Before proceeding with the installation, please read “Electrical Safety and

Installation Requirements” on page iii through xviii

Note

Installation of this product should only be performed by TRAINED

SERVICE PERSONNEL.

Power Requirements

Be sure that the voltage and frequency is either 100-120 or 200-240 VAC and

50 or 60 Hz. Since there is no external power switch, power is applied when the

power cord is connected.

Installing the Hub

Making UTP Port Connections

1. Carefully remove the AT-MR840TF hub from its packaging box. Keep the

packing materials for future use.

2. Position the hub in a location with adequate ventilation and a power

source.

3. Attach an AC cord to the hub and make sure that the POWER LED on the

front panel lights.

4. On the hub side, attach your 10Base-T UTP cables (RJ45 connectors) to the

10Base-T ports.

5. On the workstation side, attach the other end of the UTP cable to the

10Base-T network adapter card on the workstation.

MR840TF_Book Page 11 Tuesday, November 11, 1997 3:46 PM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Sem comentários

Allied-telesis AT-MR840TF Manual do Utilizador Página 31