Allied-telesis AT-MR908TX Manual do Utilizador descarregar pdf (Página 31)

AT-MR908TX Installation Manual

2. Remove all equipment from the packing box and store the box and packing

materials in a safe place. That is, the unit may need to be transferred in

the future.

3. Insert the female end of the power cord into the Power Receptacle on the

back of the unit.

4. Insert the male end of the power cord into an electrical output of the

appropriate power.

5. Check the front panel of the hub to make sure the green power (PWR) LED

is illuminated.

6. Plug all 100BASE-TX cables into the 100BASE-TX network ports (RJ-45

connectors) on the back of the unit.

Figure 6: Standalone AT-MR908TX Back Panel

7. Ensure that the MDI /MDI-X slide switch is set to MDI-X as shown in

Figure 6. This enables the use of Port 1 for a normal network connection.

8. Plug the opposite end of each 100BASE-TX cable into a network node or

workstation.

Note

The Collision Domain Diameter (total allowable distance end-to-end)

for a Class I repeater cannot exceed 200 meters. That is, the hub-to-

device connection should never be more than 100 meters in length.

You are now ready to operate your AT-MR908TX hub in a standalone, Class I,

network conﬁguration.

Port 1

Power receptacle

Network ports

MDI MDI-X switch (set to MDI-X)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 61 62

Sem comentários

Allied-telesis AT-MR908TX Manual do Utilizador Página 31