Allied-telesis AT-RPS3000 Manual do Utilizador descarregar pdf (Página 58)

Chapter 2: Installing the AT-RPS3000 Chassis and Power Supply Modules

Installing the AT-RPS3000 Chassis in an Equipment Rack

Perform this procedure to install the chassis in a 19-inch equipment rack.

The procedure requires the following items:

 Twelve bracket screws (included with chassis)

 Two equipment rack brackets (included with chassis)

 Flat-head screwdriver (not provided)

 Cross-head screwdriver (not provided)

 Four standard equipment rack screws (not provided)

Warning

The chassis may be heavy and awkward to lift. Allied Telesis

recommends that you get assistance when mounting the chassis in

an equipment rack.



E28

1. Place the unit upside down on a level, secure surface.

Figure 35. Turning the Switch Upside Down

2. Using a flat-head screwdriver, pry the six plastic feet from the bottom

of the switch.

Figure 36. Removing the Plastic Feet

2180

2168

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 91 92

Sem comentários

Allied-telesis AT-RPS3000 Manual do Utilizador Página 58