Allied-telesis AT-RPS8000 Manual do Utilizador descarregar pdf (Página 11)

AT-RPS8000 Quick Install Guide

Note

Ensure that air flow is unrestricted around the AT-RPS8000 unit.

4. Attach the provided DC power cord to the DC output connector on the

back panel of the AT-RPS8000 unit, directly behind the pre-installed

AT-PWR8000. (Refer to Figure 4 for the DC output connector.)

Figure 4

Back Panel of the AT-RPS8000 Unit

5. Connect the other end of the DC power cord to the R.P.S. Input

connector on the back panel of the Ethernet switch. (Refer to Figure 5

for the R.P.S. Input connector.)

Figure 5

Back Panel of the Ethernet Switch

6. Plug the AC power cord for the AT-RPS8000 into the AC connector on

the back panel of the unit. (Refer to Figure 4 for the AC connector.)

Note

The AT-RPS8000 unit and Ethernet switches should be connected to

power outlets on separate circuits. This will protect the switches from

a loss of power should a power circuit fail.

7. Plug the other end of the AC power cord into a wall outlet.

ON/OFF

DC Power Output Connector

AC Power Connector

Switch

R.P.S. Input Connector for the DC Power Cord

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sem comentários

Allied-telesis AT-RPS8000 Manual do Utilizador Página 11