Allied-telesis AT-S25 Manual do Utilizador descarregar pdf (Página 228)

Section III: Web Browser Management

228

Enabling or Disabling STP or RSTP

An AT-8300 Series stack can support STP and RSTP. Only one spanning

tree protocol can be active on a stack at a time. Before you can enable a

spanning tree protocol, you must first select it as the active spanning

tree protocol. Once selected, you can then enable or disable it.

To select the active spanning tree protocol and to enable or disable it,

perform the following procedure:

1. From the Home page, select Configuration.

2. From the Configuration page, select Layer 2 tab.

3. From the Layer 2 page, select the Spanning Tree tab.

The Spanning Tree window in Figure 92 is displayed.

Figure 92 Configuration - Spanning Tree Window

4. To change the active spanning tree protocol on the switch, click STP

or RSTP in the Active Protocol Version section of the window. The

default is RSTP.

5. To enable or disable spanning tree, click the Enable Spanning Tree

check box. A check indicates that the feature is enabled while no

check indicates that the feature is disabled. The default is disabled.

Note

Only one spanning tree protocol can be active on a stack at a time.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 275 276

Sem comentários

Allied-telesis AT-S25 Manual do Utilizador Página 228