Allied-telesis AT-S26 Manual do Utilizador descarregar pdf (Página 28)

Getting Started

Starting an Omega Session from a Web Browser

This section contains the procedure for starting an Omega session from

a web browser.

Note

You cannot use a web browser to manage an AT-9006 switch if the

switch is part of a non-TCP/IP network.

Before you can manage the switch in a TCP/IP environment with a web

browser, the switch must have an IP address and subnet mask. Initially,

these two parameters can only be set through the RS232 port on the

switch and a local Omega session. For instructions on establishing a local

management session, refer to Starting a Local Omega Session Using

the RS232 Port on page 23 for instructions.

To start an Omega session from a web browser, perform the following

procedure:

1. Start your web browser.

Note

If the PC with the browser is connected directly to the switch or is on

the same side of a firewall as the switch, you must configure your

browser’s network options not to use any proxies. Consult your web

browser’s documentation on how to configure the browser not to

use proxies.

2. Enter the IP address of the switch you want to manage in the URL field

of the browser, as shown in Figure 2:

Figure 2 Entering a Switch’s IP Address in the URL Field

Switch’s IP Address

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 155 156

Sem comentários

Allied-telesis AT-S26 Manual do Utilizador Página 28