Allied-telesis AT-S39 Manual do Utilizador descarregar pdf (Página 105)

AT-S39 Command Line Interface User’s Guide

105

ACTIVATE RSTP

Syntax

activate rstp

Parameters

None

Description

Use this command to designate RSTP as the active spanning tree on the

switch. A spanning tree protocol is active on a switch only if you

designate it as the active spanning tree and enable it.

Note

A change to the active spanning tree protocol will reboot the switch.

Some network traffic may be lost.

When you activate RSTP, the management software displays a prompt

asking if you want to enable the spanning tree. If you select yes, the

management software activates RSTP, resets the switch, and, once the

reset process is completed, enables RSTP. If you select no, the

management software activates RSTP and resets the unit, but does not

enable RSTP. You might select the latter if you want to configure RSTP

parameters before enabling spanning tree.

Example

The following command designates RSTP as the active spanning tree:

activate rstp

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 202 203

Sem comentários

Allied-telesis AT-S39 Manual do Utilizador Página 105