Allied-telesis AT-S84 Manual do Utilizador descarregar pdf (Página 262)

Chapter 23: Quality of Service (QoS)

262 Section II: Web Browser Interface

Mapping CoS Priorities to Egress Queues

This procedure explains how to change the default mappings of CoS

priorities to egress priority queues, as shown in Table 2 on page 127. This

is set at the switch level. You cannot set this at the per-port level. This

procedure also enables and disables QoS.

To change the default mappings of CoS priorities to egress priority queues

or to enable or disable QoS, perform the following procedure:

1. From the Advanced Config menu, select QoS Config > Traffic

Class.

The Traffic Class Configuration page opens, as shown in Figure 80.

Figure 80. Traffic Class Configuration Page

2. To enable or disable QoS, select Enable or Disable from the QoS

Status list. The default is disabled.

3. To change the egress priority queue assignment of an 802.1p priority

class, click the dialog circle of the queue for the corresponding priority.

For example, to direct all tagged traffic with a priority of 4 to egress

queue 3 on the ports, you would click the button for queue 3 in the

priority 4 row.

4. Click Apply.

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 325 326

Sem comentários

Allied-telesis AT-S84 Manual do Utilizador Página 262