Allied-telesis AR400 SERIES Software Release 2.7.1 Manual do Utilizador Página 120
- Página / 134
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
120 AR400 Series Router User Guide
Software Release 2.7.1
C613-02021-00 REV F
Figure 21: Example output from the SHOW RSVP INTERFACE command.
To interpret output from the SHOW RSVP INTERFACE command see the
Resource Reservation Protocol (RSVP) chapter in the Software Reference.
OSPF
Open Shortest Path First (OSPF) is an Internal Gateway Routing Protocol,
based on Shortest Path First (SPF) or link-state technology. OSPF is a routing
protocol that determines the best path for routing IP traffic over a TCP/IP
network.
These features are supported by OSPF:
■ Authentication of routing updates.
■ Tagging of externally-derived routes.
■ Fast response to topology changes with low overhead.
■ Load sharing over meshed links.
OSPF supports three types of physical networks—point-to-point, broadcast
and non-broadcast.
When using OSPF to route an IP packet, the router looks up the routing table
entry which best matches the destination of the packet. This routing table entry
contains the interface and nexthop router to forward the IP packet to its
destination. The routing table entry that best matches the destination is
determined first by the path type, then the longest (most specific) network
mask. At this point there may still be multiple routing entries to the
destination; if so then equi-cost multi-path routes exist to the destination. Such
equi-cost routes are appropriately used to share the load to the destination.
RSVP Interfaces
Maximum Reserved No. Of
Interface Enabled Bandwidth(%) Bandwidth(%) Reservations Debug Encap
------------------------------------------------------------------------------
Dynamic No 75 0 0 None RAW
vlan11 Yes 75 0 1 None RAW
ppp0 Yes 75 0 0 None RAW
------------------------------------------------------------------------------
- AR400 SERIES 1
- User Guide 1
- Software Release 2.7.1 1
- Contents 3
- Operating the router 4
- Introduction 7
- The Documentation Set 8
- Technical support 9
- Features of the Router 9
- Management Features 10
- Layer 3 and Other Features 10
- Warning about FLASH memory 12
- Interface (CLI) 13
- Connecting a Terminal or PC 14
- Logging In 15
- Assigning an IP Address 15
- Setting Routes 17
- Changing a Password 17
- Choosing a Password 18
- Using the Commands 18
- Getting Command Line Help 19
- Setting System Parameters 20
- Interface (GUI) 23
- What is the GUI? 24
- Pop-up Windows 25
- HTTP Proxy Servers 25
- Start here 26
- AR400 Series router 27
- Switch Ports 27
- AR400 Series Router 28
- Secure Access 31
- The Configuration Menu 34
- Using Configuration Pages 35
- Editable Fields 37
- Apply Button 37
- Cancel Button 37
- The Management Menu 38
- The Monitoring Menu 38
- The Diagnostics Menu 39
- Changing the Password 39
- Context Sensitive GUI Help 39
- Configuring Multiple Devices 40
- Upgrading the GUI 41
- Troubleshooting 42
- Deleting Temporary Files 43
- Firewall 45
- IP Addresses and DHCP 47
- Time and NTP 48
- Loading Software 49
- Normal Mode and Security Mode 53
- Remote Management 56
- Storing Files in FLASH Memory 56
- Using Scripts 57
- Loading and Uploading Files 59
- Loading Files 60
- Setting LOADER Defaults 61
- Upgrading Router Software 63
- Using the Built-in Editor 67
- SNMP and MIBs 68
- Interfaces 73
- Naming Interfaces 73
- Ethernet Ports 74
- Asynchronous Port 75
- Virtual LANs 80
- Point to Point Protocol (PPP) 81
- SHOW FRAMERELAY 82
- (ISDN) (models with PIC bay) 85
- Default Setup 86
- Testing the BRI or PRI PIC 86
- Configuring Basic Rate ISDN 87
- Configuring Primary Rate ISDN 90
- (models with PIC bay) 94
- STOP TRACE 97
- Configuring an IP Network 99
- Before You Start 100
- Configuring IP 100
- C613-02021-00 REV F 101
- Configuring IP Multicasting 103
- Configuring IGMP 104
- Multicasting using DVMRP 104
- 172.74.2.2 105
- Protocol (DHCP) 109
- Configuring IPX 112
- Network = 401 116
- Network = 12 116
- AppleTalk 118
- Point-to-Point link 121
- Router 2 121
- Router 1 121
- This Chapter 123
- How the Router Starts Up 124
- How to Avoid Problems 125
- Configure logging 126
- Configure Firewall 126
- FLASH compaction 126
- Watch for software updates 126
- Completely 127
- Regularly 128
- Resetting Router Defaults 129
Manuais e produtos relacionados com Hardware de computador Allied-telesis AR400 SERIES Software Release 2.7.1
Hardware de computador Allied-telesis AT-VIEW PLUS 3.1 MIB COMPILER Manual do Utilizador
(14 páginas)
(14 páginas)
Hardware de computador Allied-telesis AT-VIEW PLUS 3.1 DEVICE MANAGER Manual do Utilizador
(118 páginas)
(118 páginas)
Hardware de computador Allied-telesis AT-VIEW PLUS 3.1 VLAN MANAGER Manual do Utilizador
(56 páginas)
(56 páginas)
Hardware de computador Allied-telesis AT-VIEW PLUS 3.1 INSTALLATION Manual do Utilizador
(26 páginas)
(26 páginas)
Hardware de computador Allied-telesis AT-VIEW PLUS 3.0 INSTALLATION Manual do Utilizador
(26 páginas)
(26 páginas)
Hardware de computador Allied-telesis AT-VIEW PLUS 3.0 VLAN MANAGER Manual do Utilizador
(52 páginas)
(52 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais