Allied-telesis AR700 SERIES Software Release 2.7.1 Manual do Utilizador Página 54

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 53
54 AR700 Series Router User Guide
Software Release 2.7.1
C613-02047-00 REV A
When the download has completed, check that the file is in FLASH.
show file
This shows the file 52261-01.paz is present.
To activate the patch see “To upgrade to a new patch file:” on page 58.
Uploading Files From the Router
The LOADER can upload files from the router to a network host, using TFTP or
ZMODEM. Upload files using one of the commands:
upload [method=tftp] [file=filename]
[server={hostname|ipadd}]
upload [method=zmodem] [file=filename] [asyn=port]
The UPLOAD command uses defaults set with the SET LOADER command,
for parameters not specified with the upload command.
You can install Allied Telesyn’s Trivial File Transfer Protocol Server (AT-TFTPD
on any PC or server running Windows. This will provide a simple way to make
files available to all Allied Telesyn routers and layer 3 switches in your
network. The TFTP Server, and a readme file describing how to install and use
it, are provided on the Documentation and Tools CD-ROM.
Example: Upload a Configuration File Using
TFTP
This example uploads a configuration file from the router to a TFTP server on
the network. Before following this procedure, make sure:
The TFTP server is operating on a host with an IP address (for example
192.168.1.3) on the network.
The router has a valid IP address (for example 192.168.1.2) on the interface
connecting it to the TFTP server, and that it can communicate with the
server.
The configuration file is present in the router’s FLASH.
To upload a log file:
1. Configure the LOADER.
Set the LOADER module with defaults to make the process of
downloading and uploading files in future simpler.
set loader method=tftp server=192.168.1.3
2. Upload the configuration file.
Upload the configuration file from the router into the TFTP directory of the
TFTP server on the network, using the defaults set above.
upload file=filename.cfg
Monitor the load progress.
show load
When the upload is complete, check that the file is in the TFTP directory on
the network host.
Vista de página 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 117 118

Comentários a estes Manuais

Sem comentários