Allied-telesis AT-2973T (NetExtreme II) Manual do Utilizador descarregar pdf (Página 118)

Chapter 9: User Diagnostics

118

Performing Diagnostics

At the MS-DOS prompt, type uxdiag followed by the command options.

The uxdiag command options are shown in Table 7. For example, to run

all diagnostic tests except Group B tests on adapter #1, enter the following

command:

C:\>uxdiag -c 1 -t b

Note

You must include uxdiag at the beginning of the command string

each time you type a command.

Table 7. uxdiag Command Options

Command Options Description

uxdiag Performs all tests on all Broadcom

NetXtreme II adapters in your system.

uxdiag -c <devnum> Specifies the adapter (devnum) to test.

Use all in place of a specific device

number to test all adapters.

uxdiag -cof Allows tests to continue after detecting

a failure.

uxdiag -F Forces an upgrade of the image

without checking the version.

uxdiag -fbc <bc_image> Specifies the bin file to update the

bootcode.

uxdiag -fib <ib_image> Specifies the bin file for iSCSI boot.

uxdiag -fibc Programs the iSCSI configuration

block. Used only with -fib <ib_image>.

uxdiag -fibp Programs the iSCSI configuration

software. Used only with -fib

<ib_image>.

uxdiag -fipmi

<ipmi_image>

Specifies the bin file to update IPMI

firmware.

uxdiag -fmba

<mba_image>

Specifies the bin file to update the

MBA.

uxdiag -fncsi

<ncsi_image>

Specifies the bin file to update the

NCSI firmware.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 135 136

Sem comentários

Allied-telesis AT-2973T (NetExtreme II) Manual do Utilizador Página 118