Allied-telesis AT-A24/SX, LX Manual do Utilizador descarregar pdf (Página 15)

1000Base Expansion Module Quick Install Guide

Installing the Module

To install an expansion module in an Allied Telesyn switch, perform the

following steps:

1. Disconnect the switch’s power cord, if attached.

Caution

Do not install the module with the switch powered ON. Doing so can

damage the module.

Warning

The power cord is used as a disconnect device. To de-energize

equipment, disconnect the power cord. 10

2. Using a Phillips-head screwdriver, remove a blank faceplate from one of

the expansion slots on the front panel of the switch by unscrewing the

faceplate’s two captive screws. Refer to Figure 1.

Figure 1 Removing a Blank Faceplate

Note

Do not remove the faceplate if you are not installing an expansion

module in the slot.

Captive Screws

Blank Faceplate

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Sem comentários

Allied-telesis AT-A24/SX, LX Manual do Utilizador Página 15