Allied-telesis AT-S62 Manual do Utilizador descarregar pdf (Página 96)

Chapter 9: File System

Section II: Advanced Operations 96

Attributes - This can be any of the following:

❑ Normal

❑ Read Only

❑ Hidden

❑ System

❑ Volume

❑ Directory

❑ Archive

❑ Invalid

4. To change the active boot configuration file, enter the name of the file

in the Default Configuration Field field. The file must already exist in

the file system. You can select a configuration file that you created on

the switch or that you downloaded onto the switch from another

switch.

Note

You cannot create a new boot configuration file from the web

browser interface.

5. Click Apply.

The switch checks to be sure that the file exists and then displays

the file name with “Exists” following it, meaning that the switch

found the file. The file has now been designated as the new active

boot configuration file for the switch.

If the switch could not locate the file, the name of the previous

boot configuration file is displayed again. Repeat steps 4 and 5,

being sure to enter the name correctly.

6. Do one of the following:

❑ To configure the switch using the parameter settings in this boot

configuration file, do not select Save Config. Instead, reset or

power cycle the switch.

❑ To overwrite the settings in the configuration file with the switch’s

current operating settings, select Save Config.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 334 335

Sem comentários

Allied-telesis AT-S62 Manual do Utilizador Página 96