Allied-telesis AT-S63 Manual do Utilizador Página 342

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 456
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 341
Chapter 20: Multiple Spanning Tree Protocol
342 Section IV: Spanning Tree Protocols
Resetting MSTP to the Default Settings
To reset MSTP to the factory default settings, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected by
default, as shown in Figure 25 on page 94.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 135 on page 320.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 136 on
page 323.
5. Click Defaults.
The MSTP settings are returned to their default values.
6. From the Configuration menu, select the Save Config option to
permanently save your changes. (This option is not displayed if there
are no changes to save.)
Vista de página 341
1 2 ... 337 338 339 340 341 342 343 344 345 346 347 ... 455 456

Comentários a estes Manuais

Sem comentários