Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Manual do Utilizador descarregar pdf (Página 40)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

Note - The current firmware version allows the user to enter up to 64 characters for the

System Contact and the System Location parameters and up to 20 characters for the System

Name parameter.

Note - The current firmware version appends a period '.' and the value of the Default Domain

Name parameter to the value of the System Name parameter.

Firmware Info

Displays the firmware version of the switch.

Network Info

Displays network-related information such as the addresses of the default gateway and the

agents.

Manager Address Info

Displays the IP address of the management station.

Device Info

Displays general information about the switch.

Note - The Security Action parameter has a fixed value of 'do nothing' and cannot be

modified.

Note - The Security Configuration parameter has a fixed value of 'disabled' and cannot be

modified.

Note - Valid MIB Set values for the HOL Configuration and Logging Configuration

parameters are 'on' and 'off'. Attempting to set these parameters to any other value will result

in the error message: "The error occurred with 'Set' operation. Error: bad value".

Note - Valid MIB Set values for the QoS Configuration parameter are:

• mode 1

• mode 2

• mode 3

• mode 4

• mode 5

• mode 6

• mode 7

• mode 8

Attempting to set this parameter to any other value will result in the error message: "The

error occurred with 'Set' operation. Error: bad value".

DHCP Info

Displays the DHCP information about the switch.

PN 613-50665 Rev A Page 40 of 257

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 256 257

Sem comentários

Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Manual do Utilizador Página 40