Allied-telesis AT-WA7501 Manual do Utilizador descarregar pdf (Página 275)

100

101

AT-WA7500 and AT-WA7501 Installation and User’s Guide

275

You can also set the baud rate to autobaud, which lets the access point

set its baud rate to match the baud rate of your wireless end device. Type

SR 0 and press Enter twice.

Using Content

Addressable

Memory (CAM)

Mode Commands

You may need to use CAM commands to perform certain functions. Since

the Ethernet port on the access points supports data rates significantly

higher than the radio ports, all frames cannot be forwarded from the

Ethernet network to the radios. CAM, which is controlled by the Field

Programmable Gate Array (FPGA), filters frames based on the radio’s

capability.

Because the commands can cause undesirable results if not properly

executed, you should contact Technical Support for assistance if you are

unsure about the proper procedure to use.

To enter CAM mode

1. Type CAM and press Enter.

2. Enter a password. The default password is EV98203C (case

sensitive).

When you are in CAM mode, the CAM prompt (CAM>) appears.

To exit CAM mode

 At the CAM prompt, type X and press Enter.

You return to the ap prompt.

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 351 352

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-WA7501 Manual do Utilizador Página 275

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-WA7501