Allied-telesis IE200 Series Manual do Utilizador descarregar pdf (Página 57)

Chapter 5: Powering on the Switch

AT-IE200 Series Installation Guide 57

Connecting the Ground Wiring

Figure 3 on page 19 and Figure 4 on page 20 show the location of the grounding screw on the top panel of the

switch. The grounding requirements are:

 Use a minimum of #16 AWG solid copper conductor to connect the switch’s grounding

screw to the earth.

 Keep the wire length as short as possible.

 Continuity from the grounding screw to the earth ground rod must be less than 0.05

ohms.

 If a terminal is used, it should be double crimped.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 69 70

Sem comentários

Allied-telesis IE200 Series Manual do Utilizador Página 57