Allied-telesis x310 Series Manual do Utilizador descarregar pdf (Página 89)

Chapter 7

Powering On the Stack

This chapter contains the following procedures:

 “Installing the Power Cord Retaining Clip” on page 90

 “Powering On the Switches Individually” on page 91

 “Powering On the Switches Simultaneously” on page 94

 “Verifying the Stack” on page 96

 “Monitoring the Initialization Processes” on page 99

Perform “Powering On the Switches Individually” on page 91 if you want to

control the assignment of the ID numbers to the switches of the stack. The

numbers are assigned in the order in which you power on the units.

Otherwise, perform “Powering On the Switches Simultaneously” on

page 94 to have the switches assign the numbers automatically. After the

ID numbers are assigned, you may change them with the STACK

RENUMBER command, described in the Software Reference for x310

Series Switches, AlliedWare Plus Operating System.

Caution

You should not change the ID numbers of the switches after you

begin to configure the parameter settings. Otherwise, the stack

might assign configuration settings to the wrong units.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 119 120

Sem comentários

Allied-telesis x310 Series Manual do Utilizador Página 89