Allied-telesis x310 Series Manual do Utilizador descarregar pdf (Página 70)

Chapter 4: Installing the Switch on a Wall

5. Have another person hold the switch on the concrete wall at the

selected location for the device while you use a pencil or pen to mark

the wall with the locations of the two screw holes in the brackets. Refer

to Figure 27. Be sure that the selected location adheres to the

recommendations in “Recommended Minimum Wall Area Dimensions”

on page 66.

Figure 27. Marking the Locations of the Bracket Holes on a Concrete Wall

6. Place the switch on a table or desk.

7. Use a drill and a 1/4” carbide drill bit to pre-drill the two holes you

marked in step 5. Please review the following guidelines:

 Prior to drilling, set the drill to hammer and rotation mode. The

modes break up the concrete and clean out the hole.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 115 116

Sem comentários

Allied-telesis x310 Series Manual do Utilizador Página 70