
AT-S63 Version 4.0.0 Patch 2 Software Release Notes
PN 613-001166 Rev A 16 Allied Telesis, Inc.
range was 1 to 15; the new range is 0 (zero) to 15. Setting Q7 to 0 gives its packets priority
over packets in the other queues. No packets are transmitted from the lower priority queues
so long as there are packets in Q7. (3803)
Temperature threshold alert. The temperature threshold alert feature now has two levels. An
ambient temperature of 55
° to 60° Celsius for ten minutes activates the first level. The switch
sends a SNMP trap and enters a warning event message in the event logs. The second level,
activated if the ambient temperature exceeds 60
° Celsius for five minutes, sends another
SNMP trap, logs an error event message, and activates the Fault LED on the front panel.
Version 1.3.0:
Added the following new features to 802.1x port-based network access control:
— Guest VLANs
— VLAN Assignment and Secure VLAN features for supporting dynamic VLAN assignments
with supplicant accounts.
— MAC address-based authentication as an alternative to 802.1x username and password
authentication.
Simplified the menu interface for managing the access control entries in the Management
ACL.
Version 1.2.0:
MLD snooping for MLDv1 and MLDv2.
802.1x port-based network access control supports up to 20 supplicants simultaneously on
an authenticator port.
Quality of Service has the following new actions:
— Set Type of Service (ToS)
— Move Type of Service to 802.1p Priority
— Move 802.1p Priority to Type of Service
— Send to Mirror Port
The command line interface has new command parameters for displaying and deleting
specific types of MAC addresses from the MAC address table.
Version 1.1.0:
LACP (802.3ad)
Policy-based QoS (Classifiers, Flow Groups, Traffic Classes, and Policies)
Flash memory operations
Access Control Lists (ACLs)
Syslog support
Password reset
Redundant power supply information
IGMP v3 Snooping
New web browser interface procedures
Comentários a estes Manuais