Allied Telesis Switch AT-S110 Manual do Utilizador descarregar pdf (Página 112)

100

101

Chapter 7: LACP Port Trunks

112

Port Priority Configuration

To select a priority for an LACP port, perform the following procedure:

1. Select the Bridge folder.

The Bridge folder expands.

2. From the Bridge folder, select the Trunk Config folder.

The Trunk Config folder expands.

3. From the Trunk Config folder, select Port Priority.

The AT-GS950/10PS Port Priority Page is displayed. See Figure 35

for a partial view of this page.

Figure 35. AT-GS950/10PS Port Priority Page

The System Priority is a preassigned value that you cannot alter. This

value applies to the switch. See “System Priority” on page 105.

The System ID is a MAC address value assigned to the switch. You

cannot change this value.

4. To set the port priority, select a value from 0 to 255 in the Priority

column for the port you want to alter. For more information, see “Port

Priority Value” on page 106

5. Select Apply.

6. From the main menu on the left side of the page, select Save

Configuration to Flash to permanently save your changes.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 385 386

Comentários a estes Manuais

Sem comentários

Allied Telesis Switch AT-S110 Manual do Utilizador Página 112

Comentários a estes Manuais

Manuais e produtos relacionados com Software Allied Telesis Switch AT-S110