Allied-telesis AT-FS705L Manual do Utilizador descarregar pdf (Página 28)

Chapter 2: Installation

Wall-Mounting the Switch

You can mount the switch vertically on a wall using the mounting brackets

that come with the unit. The wall-mounting screws and plastic anchors

necessary to mount the switch on a wall are provided.

Note

The plastic anchors used for wall mounting the switch are intended

for installation in walls made of sheetrock or concrete materials.

To mount an AT-FS705L switch onto a wall, perform the following

procedure:

1. Remove all equipment from the package and store the packaging

material in a safe place.

2. If attached, remove the rubber feet, data cables, and power cord from

the switch.

3. Select a wall location for the switch.

4. Mark locations for two holes 7.06 cm (2.78 in) apart on the wall as

shown in Figure 4..

Figure 4. Wall Mounting Hole Dimensions

5. At the marked locations for the holes, drill the holes for the

anchors.Each hole must be 0.635 mm (0.25 in) in diameter.

6. Install the two anchors and then the two screws.

7.06cm (2.78in)

1781

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Sem comentários

Allied-telesis AT-FS705L Manual do Utilizador Página 28