Allied-telesis AT-FS705PD Manual do Utilizador descarregar pdf (Página 23)

AT-FS705PD Fast Ethernet Switch Installation Guide

Installing the Switch on a Desktop

The AT-FS705PD switch can be used on a desktop or mounted on a wall. To

wall-mount the switch, refer to “Wall-Mounting the Switch” on page 17.

To install an AT-FS705PD switch on a desktop, perform the following

procedure:

1. Remove all equipment from the package and store the packaging material

in a safe location.

2. If you are installing the switch on a desktop, attach the four protective

feet to the bottom on the unit. See Figure 5.

Note

Do not attach the protective feet if you are wall-mounting the switch.

Figure 5 Attaching the Protective Feet

3. Place the switch on a flat, secure surface (such as a desk or table) leaving

ample space around the unit for ventilation.

4. Connect the twisted pair cables to the twisted pair ports.

When connecting a twisted pair cable to a port, observe the following

guidelines:

❑ An RJ-45 connector should fit snugly into the port on the converter.

The tab on the connector should lock the connector into place.

❑ You should check to be sure that you are using the appropriate type of

twisted pair cabling. Refer to Table 3 on page 12 for twisted pair cable

specifications.

❑ Since the twisted pair port, when operating in Auto-Negotiation, is

Auto MDI/MDI-X, you can use either a straight-through or crossover

twisted pair cable to connect any type of network device to a port on

the converter. If you disable Auto-Negotiation on the port, the port

defaults to MDI-X.

AT-FS705PD

5 Port Fast Ethernet Switch

Powered Device

100 M

54321

LINK /ACT

FDX

PWR

POE

WALL

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Sem comentários

Allied-telesis AT-FS705PD Manual do Utilizador Página 23