Allied-telesis AT-FS705PD Manual do Utilizador

AT-FS705PDFast Ethernet SwitchInstallation GuidePN 613-50465-00 Rev B

Overview2Figure 1 illustrates the front and back panels of the AT-FS705PD switch.Figure 1 AT-FS705PD Switch Front and Back PanelsKey FeaturesThe AT-F

AT-FS705PD Fast Ethernet Switch Installation Guide3Status LEDsTable 1 defines the LEDs for the switch.Table 1 Status LEDsTable 2 defines the LEDs for

Overview4Powering OptionsFigure 2 Power Port, POE Port, and Twisted Pair Ports on Back PanelTwo ways to power on an AT-FS705PD switch are as follows:

AT-FS705PD Fast Ethernet Switch Installation Guide5Port SpeedThe twisted pair ports are compliant with the 10Base-T and 100Base-TX standards and are c

Overview6Auto MDI/MDI-XA twisted pair port on a 10 Mbps or 100 Mbps Ethernet network device can have one of two possible wiring configurations: MDI or

AT-FS705PD Fast Ethernet Switch Installation Guide7The switch also checks the destination MAC address of each frame it receives. The destination addre

Overview8Network TopologiesThe AT-FS705PD switch can be used in different topologies such as standalone and uplink. Each topology is describe below.St

AT-FS705PD Fast Ethernet Switch Installation Guide9UplinkFigure 4 illustrates multiple AT-FS705PD switches can be interconnected using uplinks from a

11Chapter 2InstallationThis chapter contains the installation instructions for the AT-FS705PD switch. This switch can be used on a desktop or mounted

Copyright © 2004 Allied Telesyn, Inc.960 Stewart Drive Suite B, Sunnyvale CA 94085, USAAll rights reserved. No part of this publication may be reprodu

Installation12Planning the InstallationBe sure to observe the following guidelines when planning the installation of your switch.❑ The end-nodes conne

AT-FS705PD Fast Ethernet Switch Installation Guide13Selecting a SiteBe sure to observe the following requirements when choosing a site for your switch

Installation14Reviewing Safety GuidelinesPlease review the following safety guidelines before installing the AT-FS705PD switch.WarningLightning Danger

AT-FS705PD Fast Ethernet Switch Installation Guide15Installing the Switch on a DesktopThe AT-FS705PD switch can be used on a desktop or mounted on a w

Installation16CautionPOE and power cord are used as disconnection devices: To de-energize equipment, disconnect the POE and the power cord.5. There ar

AT-FS705PD Fast Ethernet Switch Installation Guide17Wall-Mounting the SwitchThe switch can be mounted horizontally on a wall using the keyholes on the

Installation184. Position the switch horizontally onto the wall screws, as illustrated in Figure 7.Figure 7 Positioning The Switch Onto The Wall Scre

AT-FS705PD Fast Ethernet Switch Installation Guide196. Power ON the switch.There are two ways to power ON the switch; perform one of the following ste

Installation20Warranty RegistrationWhen you have finished installing the switch, you should register your switch by completing the enclosed warranty c

21Chapter 3TroubleshootingFollow the guidelines below to test and troubleshoot the installation in the event a problem occurs.If the PWR-POE LED is OF

iiiElectrical Safety and Emission Compliance StatementsStandards: This product meets the following standards:U.S. Federal Communications CommissionDec

Troubleshooting22❑ Verify that the end-node connected to the port and the switch are operating at the same speed. Both must be operating at either 10

23Appendix ATechnical SpecificationsPhysicalDimensions: W x H x D125.73 mm x 26 mm x 100.05 mm (4.95 in x 1.02 in x 3.74 in)Weight: 372 grams (0.82 lb

Technical Specifications24Agency ComplianceEMI/RFI: FCC Class B, EN55022 Class B, VCCI Class B, C-TICKElectrical Safety: EN60950 (TUV), UL60950 (cULus

AT-FS705PD Fast Ethernet Switch Installation Guide25Table 5 lists the RJ-45 connector pins and their signals used in Port 5 when this port is connecte

Technical Specifications26Table 6 lists the RJ-45 connector pins and their signals used in Port 5 when this port is connected to a PSE device using a

27Appendix BTranslated Safety and Emission InformationImportant: This appendix contains multiple-language translations for the safety statements in th

Translated Safety and Emission Information28Standards: This product meets the following standards.U.S. Federal Communications CommissionDeclaration Of

AT-FS705PD Fast Ethernet Switch Installation Guide29 1RFI Emission FCC Class B, EN55022 Class B, VCCI Class B, C-TICK 2 Immunity EN55024 3 Electric

Translated Safety and Emission Information30Normen: Dieses Produkt erfüllt die Anforderungen der nachfolgenden Normen. 1 Hochfrequenzstörung FCC Klas

AT-FS705PD Fast Ethernet Switch Installation Guide31Standarder: Dette produkt tilfredsstiller de følgende standarder. 1Radiofrekvens forstyrrelsesemi

Electrical Safety and Emission Compliance StatementsivRFI Emission FCC Class B, EN55022 Class B, VCCI Class B, C-TICK  1Immunity EN55024  2Electrica

Translated Safety and Emission Information32Eisen: Dit product voldoet aan de volgende eisen. 1RFI Emissie FCC Klasse B, EN55022 Klasse B, VCCI Klass

AT-FS705PD Fast Ethernet Switch Installation Guide33Normes: Ce produit est conforme aux normes de suivantes. 1 Emission d'interférences radioéle

Translated Safety and Emission Information34Standardit: Tämä tuote on seuraavien standardien mukainen. 1 Radioaaltojen häirintä FCC Luokka B, EN55022

AT-FS705PD Fast Ethernet Switch Installation Guide35Standard: Questo prodotto è conforme ai seguenti standard. 1 Emissione RFI (interferenza di radio

Translated Safety and Emission Information36Sikkerhetsnormer: Dette produktet tilfredsstiller følgende sikkerhetsnormer. 1 RFI stråling FCC Klasse B,

AT-FS705PD Fast Ethernet Switch Installation Guide37Padrões: Este produto atende aos seguintes padrões. 1 Emissão De Interferência De Radiofrequência

Translated Safety and Emission Information38Estándares: Este producto cumple con los siguientes estándares. 1Emisión RFI FCC Clase B, EN55022 Clase B

AT-FS705PD Fast Ethernet Switch Installation Guide39Standarder: Denna produkt uppfyller följande standarder. 1Radiostörning FCC Klass B, EN55022 Klas

vTable of ContentsElectrical Safety and Emission Compliance Statements ...iiiTable of Contents ...

viInstalling the Switch on a Desktop...15Wall-Mounting the Switch ...

viiThis guide contains instructions on how to install and configure the AT-FS705PD Fast Ethernet Switch.Where to Find Related GuidesThe Allied Telesyn

Welcome to Allied TelesynviiiContacting Allied Telesyn This section provides Allied Telesyn contact information for technical support as well as sales

1Chapter 1OverviewThe AT-FS705PD is a 5-port Unmanaged Fast Ethernet Switch that includes one Power-Over-Ethernet (POE) port. This switch is considere