Allied-telesis AT-S65 Manual do Utilizador descarregar pdf (Página 31)

AT-S65 Management Software User’s Guide

3. Enter or change the parameters as desired.

Changes to the parameters take effect immediately on the chassis.

The traps are described in Table 2.

Table 2. SNMP Traps

Trap Description

Chassis Over-Temperature The chassis temperature has exceeded

the set threshold. For information about

setting the chassis temperature threshold,

refer to “Configuring the Chassis

Temperature Threshold” on page 33.

Module Over-Temperature The temperature of a line card has

exceeded the set threshold. For

information about setting the line card

temperature threshold, refer to

“Configuring the Line Card Temperature

Threshold” on page 34.

SFP Over-Temperature The SFP transceiver’s temperature has

exceeded the set threshold. For

information about setting the SFP

temperature threshold, refer to

“Configuring the SFP Temperature

Threshold” on page 35.

SFP Loss of Signal The SFP has been disconnected from the

client port fiber.

Module Loss of Signal The line port has been disconnected from

the line port fiber.

Module Out of Sync The line card is out of synch.

SFP Insertion/Removal An SFP has been inserted into or

removed from a line card.

Module Insertion/Removal A line card has been inserted into or

removed from the system.

RPS Failure A redundant power supply (RPS) has

failed.

RPS Insertion/Removal An RPS has been inserted into or

removed from its slot.

Port Active/Shutdown The port is active or has been shut down.

Fan Failure A failure has occurred in one of the fan

modules.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 101 102

Sem comentários

Allied-telesis AT-S65 Manual do Utilizador Página 31