Allied-telesis AT-S86 Manual do Utilizador descarregar pdf (Página 106)

Chapter 10: STP and RSTP

106

5. In the Bridge Priority field, enter a number for the priority number for

the bridge. This number is used to determine the root bridge for RSTP.

The bridge with the lowest priority number is selected as the root

bridge. If two or more bridges have the same priority value, the bridge

with the numerically lowest MAC address becomes the root bridge.

When a root bridge goes offline, the bridge with the next priority

number automatically takes over as the root bridge. This parameter

can be from 0 (zero) to 61,440 in increments of 4096, with 0 being the

highest priority. For a list of the valid values, refer to Table 4, ”Bridge

Priority Value Increments” on page 95.

To configure the ports, refer to “Configuring the Spanning Tree Port

Settings,” next.

6. Do one of the following:

 Click OK to save the changes.

 Click Reload to restore the previous settings.

7. To permanently save these settings in the configuration file, from the

main menu, select Save Configuration.

The Save Configuration page is shown in Figure 3 on page 21.

8. Click Save.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 147 148

Sem comentários

Allied-telesis AT-S86 Manual do Utilizador Página 106