Allied-telesis AlliedView-EMS 4.0.3 Device-Management Manual do Utilizador Página 400

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 468
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 399
AlliedView™-EMS 4.0.3 Device Management Guide Page 400 of 468
Note - When multiple units of the AT-x900-24X series are stacked together, the
'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM
module in the device.
Received Address
Displays the address for which the system will accept packets/frames on the
particular interface.
Note - The Received Address parameter is not applicable to the AT-x900-24X series
(AlliedWare Plus) and should be ignored.
Note - The Received Address Status and Received Address Type parameters are
implemented as 'read-only'.
Note - When multiple units of the AT-x900-24X series are stacked together, the
'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed
XEM module in the device.
Spanning Tree Info
Standard
Displays the port's spanning tree parameters.
Note - Valid MIB Set values for the Port Path Cost parameter is in the range
[1-65535] inclusive.
Note - The current firmware version does not allow the Port parameter
to be configured.
Note - The current firmware version does not allow the Port Priority, Port,
Port Path Cost and Path Cost Contribution parameters to be configured.
Note - The current firmware version intermittently returns a non-
consecutive order of the port numbering when the XEM module is
interchanged.
Note - When multiple units of the AT-x900-24X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.
Additional Info
Displays additional information on the port's spanning tree parameters.
Note - The current firmware version does not allow the Protocol Migration
parameter to be set to 'true'.
Note - The current firmware version does not allow the Point-to-Point
Config parameter to be set to 'auto'.
Vista de página 399
1 2 ... 395 396 397 398 399 400 401 402 403 404 405 ... 467 468

Comentários a estes Manuais

Sem comentários