
AR720 ROUTER QUICK START GUIDE 17
Configuring an IP Network
Protocol (PPP) over a wide area link. Each router is attached to
an Ethernet LAN on which there is a mixture of PCs and hosts.
BEFORE YOU START
1 Ensure that the routers to be configured are connected to
the Ethernet LAN and the wide area link, and that the link is
operational. See Getting Connected for information about
connecting the router to a physical network.
2 Connect a terminal to the console port (port 0) on each
router, as described in the AR700 Series Router Quick Install
Guide. Alternatively, you can connect a PC to the console port
Head Office Router Remote Office Router
172.16.254.2
Remote PC Remote PC
172.16.254.1
172.16.8.33 192.168.31.30
172.16.8.0
192.168.31.16
TCP/IP Host
Local PC
PPP Data Link
Head Office Router Configuration Parameter Remote Office Router
eth0 Ethernet interface eth0
172.16.8.33 Ethernet interface IP address 192.168.31.30
172.16.8.0 Ethernet LAN IP subnet address 192.168.31.16
255.255.255.0 Ethernet LAN IP subnet mask 255.255.255.240
ppp0 PPP interface ppp0
172.16.254.1 PPP interface IP address 172.16.254.2
172.16.254.0 PPP interface IP subnet address 172.16.254.0
255.255.255.0 PPP interface IP subnet mask 255.255.255.0
TCP/IP is the most widely used network protocol. The Internet
uses TCP/IP for routing all its traffic. TCP/IP provides a range of
services including remote login, Telnet, file transfer (FTP), Email
and access to the World-Wide Web.
The AR720 router routes TCP/IP across the wide area network
using services like ISDN, Frame Relay and leased lines, enabling
remote TCP/IP LANs to be joined together as a single internet
to exchange information.
This example illustrates the steps required to configure TCP/IP
using the router’s command line interface. Two routers running
TCP/IP will be connected together using the Point-to-Point
Comentários a estes Manuais