Allied-telesis AT-8116 Manual do Utilizador descarregar pdf (Página 73)

15-1

Chapter 15

Using an SNMP Manager

This chapter contains instructions for the conﬁguration and

management of the AT-8116 SNMP Management System.

Configuring the AT-8116 SNMP Agent

Once connected to the network and powered ON, the AT-8116 starts

operating according to factory-set default values. However, to ensure

proper operation and maximum performance speciﬁc to your

network conﬁguration and to provide SNMP access, some

environment-speciﬁc parameters must be conﬁgured through the

Command Line Interface.

If you are conﬁguring the switch for the ﬁrst time:

Global Setup 1. Connect a terminal to the RS-232 connector.

2. Log in to the Command Line Interface.

3. Initialize all the AT-8116 parameters to their default values (see

Table 1, System Default Values). Use the following command

sequence:

init-nvram (deletes all current NVRAM configrations)

warm-reset (loads the NVRAM configuration)

4. Wait until you see the LOGIN prompt again. Login to the CLI. Now

all system parameters have been initialized to their default values.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 87 88

Sem comentários

Allied-telesis AT-8116 Manual do Utilizador Página 73