Allied-telesis AT-GS950/48 Manual do Utilizador descarregar pdf (Página 42)

Chapter 2: Installation

Installing an SFP Transceiver

The AT-GS950/48 Gigabit Ethernet Smart switch has four SFP combo

ports. Perform this procedure before “Cabling and Powering On the

Switch” on page 44.

To install an SFP transceiver, perform the following procedure:

Note

The transceiver can be hot-swapped; you do not need to power off

the switch to install a transceiver. However, always remove the

cables before removing the transceiver.

Note

You must install the transceiver before you connect cables to it.

1. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

2. Remove the dust plug from the SFP slot, as shown in Figure 11.

Figure 11. Removing the Dust Plug from the SFP Slot

3. Locate the label on the transceiver and turn it so that the label is on top

and the alignment groove is on the bottom.

1753

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 59 60

Sem comentários

Allied-telesis AT-GS950/48 Manual do Utilizador Página 42