Allied-telesis AT-PBC18 Manual do Utilizador descarregar pdf (Página 90)

Installing a Switch Module

3. Check the setting of the J6 jumper. If the chassis does not contain an

AT-PBM02 management module, set the jumper to Enabled (RIGHT).

The factory default setting is Disabled (LEFT) indicating that an

optional management module is installed. See Figure 33 on page 83

for the location of the jumper.

Note

If you have an earlier version of an AT-PB200 or AT-PB202/x Series

Switch (without a J6 jumper) and are using an AT-PBM02

management module to manage the chassis, the ML LED on the

switch may not function properly.

4. Configure the DIP switches. Refer to Table 37 for the possible

settings and Figure 32 for the location of the DIP switches. See DIP

Switches on page 82 for additional information.

Table 37 DIP Switch Settings for the PowerBlade Switch Modules

DIP

Switch

Number

Port

1. TX = Twisted Pair Port / FX = Fiber Optic Port.

Setting Position Description

1 TX Speed

(Mbps)

DOWN

The twisted pair port is

operating at 10 Mbps.

The twisted pair port is

operating at 100 Mbps.

2TXDuplex

Mode

DOWN

The twisted pair port is

operating at half-duplex.

The twisted pair port is

operating at full-duplex.

3 TX Auto Neg UP

DOWN

Auto-negotiation on the

twisted pair port is OFF.

Auto-negotiation on the

twisted pair port is ON.

4FXDuplex

Mode

DOWN

The fiber optic port is

operating at half-duplex

mode.

The fiber optic port is

operating at full-duplex

mode.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 119 120

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-PBC18 Manual do Utilizador Página 90

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-PBC18