Allied-telesis AT-S62 Manual do Utilizador descarregar pdf (Página 232)

100

101

Chapter 14: Event Log and Syslog Server Commands

232 Section II: Advanced Operations

ADD LOG OUTPUT

Syntax

add log output=

output-id

module=[all|

module

]

severity=[all|

severity

]

Parameters

output Specifies the output definition ID number.

module Specifies what AT-S62 events to filter. The available

options are:

all Sends events for all modules. This is the

default.

module Sends events for specific module(s). You

can select more than one module at a

time, for example, MAC,PACCESS. For a

list of modules, see Table 8, “AT-S62

Modules” on page 251.

severity Specifies the severity of events to be sent. The

options are:

all Sends events of all severity levels.

severity Sends events of a particular severity.

Choices are I for Informational, E for Error,

W for Warning, and D for Debug. You can

select more than one severity at a time (for

example, E,W). For a definition of the

severity levels, see Table 9, “Event Log

Severity Levels” on page 253. The default

is I, E, and W.

Description

This command configures an output definition.

Note

This version of the AT-S62 management software supports only

syslog servers as output definitions.

There are two steps to creating a output definition from the command line

interface. The first is to create the definition using “CREATE LOG

OUTPUT” on page 234. With that command you assign the definition an

ID number, the IP address of the syslog server, and other information.

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 655 656

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S62 Manual do Utilizador Página 232

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S62