Allied-telesis AT-S62 Manual do Utilizador descarregar pdf (Página 338)

Chapter 19: IGMP Snooping Commands

338 Section II: Advanced Operations

SET IP IGMP

Syntax

set ip igmp [snoopingstatus=enabled|disabled]

[hoststatus=singlehost|multihost] [timeout=

value

]

[numbermulticastgroups=

value

]

[routerport=

port

|all|none|auto]

Parameters

snoopingstatus Activates and deactivates IGMP snooping

on the switch. The options are:

enabled Activates IGMP snooping.

disabled Deactivates IGMP snooping.

This is the default setting.

hoststatus Specifies the IGMP host node topology.

Options are:

singlehost Activates the Single-Host/Port

setting, which is appropriate

when there is only one host

node connected to a port on

the switch. This is the default

setting.

multihost Activates the Multi-Host

setting, which is appropriate if

there is more than one host

node connected to a switch

port.

timeout Specifies the time period in seconds at

which the switch determines that a host

node is inactive. An inactive host node is a

node that has not sent an IGMP report

during the specified time interval. The range

is from 0 second to 86,400 seconds (24

hours). The default is 260 seconds. If you

set the timeout to zero (0), the timer never

times out, and the timeout interval is

essentially disabled.

This parameter also controls the time

interval used by the switch in determining

whether a multicast router is still active. The

switch makes the determination by watching

1 2 ... 333 334 335 336 337 338 339 340 341 342 343 ... 655 656

Comentários a estes Manuais

Sem comentários