Allied-telesis AT-S63 Manual do Utilizador descarregar pdf (Página 34)

100

101

Chapter 1: Basic Switch Parameters

34 Section I: Basic Operations

Pinging a Remote System

This procedure instructs the switch to ping a node on your network. This

can be useful in determining whether an active path exists between the

switch and another network device. Note the following before performing

this procedure:

Note

The switch must have a routing interface on the local subnet from

where it is pinging the end node. The switch uses the IP address of

the interface as its source address when pinging the device. For

background information on routing interfaces, refer to the AT-S63

Management Software Features Guide.

To instruct the switch to ping a network device, perform the following

procedure:

1. From the home page, select Monitoring.

2. From the Monitoring menu, select the Utilities option.

3. Select the Ping Client tab.

The Ping Client tab is shown in Figure 3.

Figure 3. Ping Client Tab (Monitoring)

4. Enter the IP address of the end node to be pinged by the switch.

5. Click OK. The results of the ping are displayed in a popup window.

6. To stop the ping, click OK.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 411 412

Comentários a estes Manuais

Sem comentários

Allied-telesis AT-S63 Manual do Utilizador Página 34

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Allied-telesis AT-S63