Allied-telesis AT-S70 Manual do Utilizador descarregar pdf (Página 108)

Chapter 8: Operations, Administration, and Maintenance (OAM)

108

The OAM Loopback Test Menu, shown in Figure 49, is displayed.

Figure 49. OAM Loopback Test Menu

8. From the OAM Loopback Test Menu, select Enable Remote

Loopback to enable the remote loopback, or select Disable Remote

Loopback to disable the remote loopback test. The default is

disabled.

When remote loopback is enabled, the local MAC Client stops sending

data frames to the remote station and the local OAM Client sets its

action parameter to DISCARD.

9. Press <Esc> or select the “Return to ...” option at the bottom of the

menu, to save the settings and return to the previous menu.

Starting or

Stopping

Loopback Test

To start or to terminate the OAM loopback test, perform the following

procedure:

1. From the Main Menu, select Module Status and Configuration.

The Module Status and Configuration Menu, shown in Figure 41 on

page 94, is displayed.

2. Select a line card on which you want to configure.

3. Press <Return>.

The Module Configuration Menu, shown in Figure 42 on page 95, is

displayed.

4. Select the port that you want to configure the OAM operations on.

5. Press <Return>.

OAM Loopback Test

Module = 5, Port = 1

Enable Remote Loopback

> Disable Remote Loopback

Start Loopback Test

> Stop Loopback Test

Show Loopback Test Statistics

Clear Loopback Test Statistics

Return to OAM Configurations ...

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 133 134

Sem comentários

Allied-telesis AT-S70 Manual do Utilizador Página 108