Allied-telesis AT-S99 Manual do Utilizador descarregar pdf (Página 179)

AT-S73 and AT-S99 Management Software User’s Guide

179

2. To configure a remote line card, select the card in the menu. This

displays the Remote Module Configuration Menu shown in Figure 77.

Figure 77. Remote Module Configuration Menu

The menu displays the current settings of the two ports on the remote

line card. The columns are described in Table 15 on page 139.

Note

You cannot disable ports or change the operating modes or the

OAM settings on remote line cards.

Your changes to the parameter settings on a remote line are

automatically saved in the card’s configuration file in flash memory.

They are retained even if the remote chassis is powered off or the card

is removed from the unit. For further information, refer to

“Configuration Files” on page 29.

3. When you finish configuring the remote line card, return to the Remote

Module Configuration Menu and select Return to Remote Module

Status and Configuration to display the Remote Module Status and

Configuration menu again.

Naming a Remote

Line Card

To assign a name to a remote line card:

1. From the Remote Module Configuration Menu, select the Module

Name field.

2. Enter a name of up to eight alphanumeric characters.

Remote Module Configuration Menu

Converteon

Module 1

Module: AT-CM202

Port Link Speed Mode

A(100BaseFX) Online 100M Full

B(100BaseTX) Online 100M Full

Module Name Module Name

Line Card Configuration

Return to Remote Module Status and Configuration ...

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 319 320

Sem comentários

Allied-telesis AT-S99 Manual do Utilizador Página 179