Allied-telesis SwitchBlade x3112 Manual do Utilizador descarregar pdf (Página 170)

Chapter 7: Powering On the Chassis

170

Figure 127. Removing the Terminal Screws

5. With a #3 Phillips-head screwdriver, connect the power lead wires to

the positive and negative terminals on the power supply, with the

terminal screws removed in step 4. The positive terminal is on the left

and the negative terminal is on the right. You may attach the terminals

with the wires either above or below the terminal block. Figure 128 on

page 171 shows the wires above the terminal block.

Allied Telesis recommends tightening the screws to 30 to 40 inch-lbs.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 221 222

Sem comentários

Allied-telesis SwitchBlade x3112 Manual do Utilizador Página 170