Allied-telesis x610 Series Layer 3 Manual do Utilizador descarregar pdf (Página 99)

x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide

Powering on a Switch with an AC Power Supply Module

To power on a switch with an AC Power Supply Module, perform the

following procedure:

1. Position the power cord retaining clip in the up position, as shown in

Figure 57. Note that the AT-PWR1200 power supply does not have a

retaining clip.

Figure 57. Power Cord Retaining Clip in the Up Position

2. Plug the power cord into the AC power conne

ctor on the rear panel of

the unit, as shown in Figure 58. Lower the power cord retaining clip to

secure the power cord to the unit.

Figure 58. Connecting the AC Power Cord

3. Connect the other end of the power cord to an appropriate AC power

outlet. For power specifications for the switch, refer to “Power

Specifications” on page 114.

Warning: Power cord is used as a disconnection device. To de-

energize equipment, disconnect the power cord.



100-240VAC

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 119 120

Sem comentários

Allied-telesis x610 Series Layer 3 Manual do Utilizador Página 99