Allied Telesis AT-FS7016 Guia de Instalação descarregar pdf (Página 25)

AT-FS7016 and AT-FS7024 Installation Guide

Installing the Switch on a Table or Desktop

If you are rackmounting an AT-FS7016 or AT-FS7024 switch, refer to

“Rackmounting the Switch” on page 17.

To install the switch on a table or desktop, perform the following procedure:

1. Remove all equipment from the packaging and store the packing material

in a safe place. In the event a problem occurs and you need to return the

unit, please use as much of the original shipping material as possible.

2. For the AT-FS7016 switch, attach the four protective feet to the bottom of

the unit. See Figure 7.

Figure 7 Attaching the Rubber Feet (AT-FS7016 only)

Note

The protective rubber feet for the AT-FS7024 switch are pre-installed.

3. Place the switch on a flat, secure surface leaving ample space around the

switch for ventilation.

4. Apply power to the switch by plugging the AC power cord into an AC power

outlet; then plug the other end of the power cord into the receptacle located

on the back of the switch.

5. Verify that the POWER LED is green. If the LED is OFF, refer to

“Troubleshooting” on page 21.

Note

The switch performs a self-diagnostic test upon power up. This takes

about 20 seconds to complete.

6. Connect the twisted pair cables to a twisted pair ports on the switch and on

the end-nodes. When connecting a twisted pair cable to a port on the switch,

observe the following:

❑ An RJ-45 connector should fit snugly into the port on the switch. The

tab on the connector should lock in connector into place.

AT-FS7016

16 Port Fast Ethernet Smart Switch

10 12 14 16

9111315

2468

1357

AUTO

MDI/ MDI-X

POWER

LINK/ACT

100M

FDX

12345678910111213141516

RS-232 TERMINAL PORT

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Sem comentários

Allied Telesis AT-FS7016 Guia de Instalação Página 25