Allied Telesis Patch 54266-02 Manual do Utilizador descarregar pdf (Página 10)

10 AR441S ADSL Router Hardware Platform Patch Release Note

Patch 54266-03

C613-10417-00 Rev C

When the set bridge port command was executed, the bridge configuration

resulting from the create config or show config dynamic=bridge

commands would be incorrect. This issue has been resolved.

The ADSL interface, adsl0, did not appear in the Interface Name Summary

table section of the show interface command output or in the

arInterfaceTable in the Allied Telesyn enterprise MIB. This issue has been

resolved.

Level 4

If VRRP was enabled and a reset ip command was issued followed by a

disable vrrp command, then the device would still reply to pings, even

though the device was no longer the VRRP master. Duplicate echo replies

were seen on the device sending the pings. This issue has been resolved.

Enhancements

The new command show tacplus has been added. This command shows the

module status, number of servers, and number of logged in users.

The new ADSL Annex B firmware has been incorporated to allow

compliance with UR-2 specifications.

AR441S ADSL Router Hardware Platform

Patch 54266-01 includes support for the AR441S ADSL (Annex B) router.

Each AR441S router consists of a base CPU card, enclosure, and power supply.

The base CPU card supports:

■ One Asymmetric Digital Subscriber Line (ADSL) Annex B port.

■ Five 10/100 LAN switch ports.

■ One asynchronous RS-232 (ASYN0) port.

PCR: 40610 Module: BRIDGE Level: 3

PCR: 40676 Module: ADSL, CORE Level: 3

PCR: 40441 Module: IPG, VRRP Level: 4

PCR: 40521 Module: TACACS+

PCR: 40677 Module: ADSL

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Allied Telesis Patch 54266-02 Manual do Utilizador Página 10