6 Features in 54266-02 Patch Release Note
Patch 54266-03
C613-10417-00 Rev C
Particular IP packets (unicast destination IP, but multicast destination MAC)
could result in a memory leak, which in some cases could cause the device to
stop responding to the command line. This issue has been resolved.
The enable switch learning command would fail if 802.1X port
authentication was enabled on any of the switch ports. This issue has been
resolved.
The router was accepting network RIP packets from foreign subnets. This
issue has been resolved.
The router could reboot when a user changed the Rendezvous Point
Candidate (RPC) priority in the PIM6 module. This issue has been resolved.
When the router was the initiator in an ISAKMP Quick mode exchange with
a PC running Windows 2000 or Windows XP, the IPSEC communication
would not establish successfully. This was because the Windows PC set the
commit bit in the exchange, but sent the CONNECTED Notify payload in
the Quick mode exchange. However, the router was waiting for an
Informational Exchange containing a Notify payload (with the
CONNECTED Notify Message) as specified by RFC 2408. Because an
Informational message was expected, the device did not process the Quick
mode CONNECTED message, and so the exchange was never committed.
Although this behaviour is described as "not required by the IKE standard"
[http://www.microsoft.com/technet/community/columns/cableguy/
cg0602.mspx], the device will now process CONNECTED messages
received in Quick mode exchanges, to allow interoperability with other
vendors.
When BGP redistributed routes, locally imported routes were selected
rather than peer learnt routes. This issue has been resolved.
For OSPF-originated routes, it was possible for a route to be deleted from
the IP routing table, but still be referenced by OSPF. This could cause a
router reboot when later generating a summary LSA that contained the old
route. This occurred using the reset ip command. This issue has been
resolved.
PCR: 40453 Module: PIM Level: 2
PCR: 40456 Module: IPG Level: 2
PCR: 40458 Module: IPG Level: 2
PCR: 40465 Module: PIM6, PIM4 Level: 2
PCR: 40466 Module: ISAKMP Level: 2
PCR: 40470 Module: BGP Level: 2
PCR: 40479 Module: OSPF Level: 2
(18 páginas)
(48 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais