Allied Telesis AT-S80 Guia do Utilizador descarregar pdf (Página 164)

Chapter 15: Basic Switch Parameters

164 Section II: Using the Web Browser Interface

Configuring an IP Address, Subnet Mask and Gateway Address

This procedure explains how to change the IP address, subnet mask, and

gateway address to the switch. Before performing the procedure, note the

following:

 The switch does not need an IP address, subnet mask, or default

gateway for normal network operations. These parameters must be

assigned values only if you plan to remotely manage the device with a

web browser from a management workstation on your network.

 A gateway address is only required if your remote management station

is separated from the switch by a router.

 To configure the switch to automatically obtain its IP configuration from

a DHCP server, go to “Enabling and Disabling the DHCP Client” on

page 166.

 The initial assignment of an IP address must be made through a local

management session using the menus interface.

To change the switch’s IP configuration, perform the following procedure:

1. From the Basic Config menu, select IP Config.

The IP Configuration page is shown in Figure 45.

Figure 45. IP Configuration Page

2. Change the IP configuration parameters by entering new information

in the fields:

System MAC Address

This parameter displays the MAC address of the switch. You cannot

change this parameter.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 241 242

Sem comentários

Allied Telesis AT-S80 Guia do Utilizador Página 164