Allied-telesis AT-8324 Manual do Utilizador descarregar pdf (Página 13)

AT-8316F and AT-8324 Quick Install Guide

Figure 4

Fault LED

7. If you purchased a redundant power supply (RPS) unit for the Ethernet

switch, connect the RPS unit to the R.P.S. Input connector (Figure 3) on

the rear of the switch by following the directions included with the RPS

system.

Caution

If you intend to use a redundant power supply (RPS) with the

switch, check to be sure that the cable with the RPS unit is

compatible with the RPS Input Port on the switch. The pin

assignments for the port are provided in the section “R.P.S. Input

Connector Specifications” on page 13.

8. Connect the data cables, making sure each connection has a good valid link

and that the switch is receiving packets.

9. Go to the procedure “Setting Up for Local Management” on page 10 to

access the Omega management software on the switch.

STATUS

RESET

FAULT

RPS

PWR

RS-232

TERMINAL PORT

MASTER

Fault LED

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Sem comentários

Allied-telesis AT-8324 Manual do Utilizador Página 13