Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manual do Utilizador descarregar pdf (Página 99)

User Access Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A AlliedWare Plus

Operating System - Version 5.4.4C 5.13

line

Use this command to enter line configuration mode for the specified VTYs or the console.

The command prompt changes to show that the switch is in Line Configuration mode.

Syntax line vty <first-line> [<last-line>]

line console 0

Mode Global Configuration

Usage In Line Configuration mode, you can configure console and virtual terminal settings,

including setting speed (asyn), length (asyn), privilege level, and authentication (login

authentication) or accounting (accounting login) method lists.

To change the console (asyn) port speed, use this line command to enter Line

Configuration mode before using the speed (asyn) command on page 8.64. Set the

console speed (Baud rate) to match the transmission rate of the device connected to the

console (asyn) port on your switch.

Note that line configuration commands do not take effect immediately. Line configuration

commands take effect after one of the following commands or events:

■ issuing a clear line console command

■ issuing a reboot command

■ logging out of the current session

Examples To enter Line Configuration mode in order to configure all VTYs, use the commands:

To enter Line Configuration mode to configure the console (asyn 0) port terminal line, use

the commands:

Parameter Description

<first-line> <0-32> Specify the first line number.

<last-line> <0-32> Specify the last line number.

console The console terminal line(s) for local access.

vty Virtual terminal for remote console access.

awplus#

configure terminal

awplus(config)#

line vty 0 32

awplus(config-line)#

awplus#

configure terminal

awplus(config)#

line console 0

awplus(config-line)#

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 221 222

Sem comentários

Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manual do Utilizador Página 99